Troubleshooting in the way of the car Hyundai Tucson 2

Alarm system when stopping on the road
Emergency light signaling Hazard warning lights warn other drivers to be extra careful when approaching, overtaking or passing a vehicle. It should be used for all...

In the event of an emergency while driving
If the engine stalls at an intersection or crossing 1. If the engine stalls at an intersection or level crossing, move the shift lever to N (neutral) and then manually...

Starting the engine from an external source of electricity
Connect cables in forward numbering sequence, and disconnect in reverse order. Starting the engine from an external source This way of starting the engine can be...

If the engine overheats
If the temperature gauge indicates overheating, there is a decrease in power, a loud hum or knock is heard, most likely the engine has overheated. In this case, you...

Tire pressure monitoring system (TPMS)
1. Low Tire Pressure Warning/TPMS Fault Indicator. 2. Position indicator for low tire pressure. In cold weather, each tire should be checked monthly, including the spare...

If a flat tire (spare tire)
Jack and tools 1. Jack handle. 2. Jack. 3. Wheel wrench. The jack, jack handle and wheel wrench are stored in the trunk. To access the equipment, lift the trunk lid....

If a tire is flat (TireMobilityKit)
Read the instructions before using the TireMobilityKit. 1. Compressor. 2. A bottle of sealant. With the TireMobilityKit, you can keep moving even after a puncture. The...

Towing — general information
Towing Service If emergency towing is required, an authorized Hyundai dealer or commercial towing service is recommended. Proper lifting and towing procedures must be...

Replacing fuses
Fuses Fuses are used to protect the vehicle's electrical system from failure due to electrical overload. This vehicle has two (or three) fuse panels. One is located...

Vehicle checks before driving
Before each trip, the driver should check the following: Outside car: 1. General condition and appearance of the car. 2. The condition of the wheels and tires, as well...

Starting the engine — checks
Engine started and running properly 1. Before starting the engine, it is necessary to install the gear selector lever (AKP) into position «R», or in position «N» if the...

Getting Started — Checks
The car started moving without problems 1. Before driving, you must fasten your seat belt. 2. Always try to start moving smoothly, because while the car has a minimum...

Checks while driving
1. While driving, always pay attention to the instrument panel and signaling devices. 2. It is necessary to pay attention to the behavior of the car when driving in a...

Determination of engine malfunctions by the condition of the spark plugs
Useful information for the driver about the operation of the gasoline engine and its individual units are spark plugs. By their appearance, it is possible to timely...

Diagnostics and cleaning of fuel injectors
Very often, a motorist has to deal with increased fuel consumption, a drop in power, and sometimes with a complete refusal of the car to move. The most common cause of...

Vehicle malfunctions
The following illustrations will simplify the definition of a particular malfunction. Noticing any abnormalities on your vehicle (extraneous noises, knocks, leaks, signs...

Types of tire tread wear
Visual inspection of the condition of the tire tread allows you to determine with a high degree of accuracy the cause of uneven wear, the elimination of which will...