Repair of power electrical equipment Hyundai Elantra 1

General description of the battery
The battery is the first link in the chain of mechanisms that work to power the engine. In most modern cars, it is of the lead-acid type, consisting of six batteries...

Battery maintenance and testing
Weekly battery maintenance includes checking the electrolyte level in each cell (bank), to make sure that the separator plates are covered with electrolyte 6 mm above...

Filling with electrolyte, checking and charging the battery
If the battery is in a fully charged state and one of the cans has a density value that is 0.025 g/cm 3 higher or lower than the value in the other cans, and it is...

General description of the generator
Depending on the models and equipment, alternators of various capacities are installed in cars. The power is indicated on the generator plate. When installing additional...

Generator — removal and installation
Typical Generator Installations A - models without air conditioning; B - drive models; 1 - generator; 2 - drive belt; 3 - bolt; 4 - generator connectors; 5 - spring; 6 -...

Generator — disassembly, replacement of needle brushes
Disassembly Remove the generator. Remove the three through bolts and disconnect the support flange on the drive side from the stator. Carefully clamping the rotor in a...

General description of the starter
Starter elements 1 - front cover; 2 - washer; 3 - thrust ring; 4 - retaining ring; 5 - overrunning clutch (bendix); 6 - lever; 7 - retractor relay; 8 - anchor; 9 -...

Start relay — check and replace
Traction relay connection diagram With a defect in the traction turnip, the starter gear does not engage the flywheel ring gear, and the starter does not crank the...

Starter Troubleshooting
If the starter fails, you must first check the presence of voltage on terminal 50 of the traction relay. It must be at least 8 V. If the voltage is less than 8 V, check...

Algorithm for troubleshooting the engine start system (battery-starter-generator)
The crankshaft does not turn, there is no click of the traction relay Slow turning of the crankshaft, clicks or rattling in the traction relay