Car steering repair Hyundai Elantra 1

General description of steering
Depending on the model and year of manufacture, the car uses rack and pinion steering with or without hydraulic booster. The steering includes a steering wheel, a...

Steering wheel — removal and installation
The position of the steering column in the car Attention: The removal of the steering wheel on models equipped with an airbag must be carried out in specialized...

Checking anthers and tie rod ends
The tie rod ends at the outer ends of the tie rods consist of steel ball heads which are contained in a plastic bushing with little lubrication and require no...

Tie rod end — removal and installation
Withdrawal Slightly loosen the wheel nuts of both front wheels on the ground. Mark the position of the rim on the wheel hub with paint. Place the front of the car on...

Cuffs of the steering mechanism — removal and installation
Raise the car on a lift. Remove the tie rod end. Loosen the clamps at both ends of the cuff, remove the rubber cuff. Installation Apply to the tie rod (3) lubricant....

Check of tightness of system of a steering
If there is no liquid in the compensation tank, the steering system must be checked for leaks. Start the engine, leaving it to idle. Build up maximum pressure in the...

Removing the reward from the steering system
When changing the fluid, clean the filter with clean gasoline. Fill the expansion tank up to the MAX mark. Raise the vehicle. Rotate the oil pump pulley. With the engine...

Changing fluid in the steering system
Raise the front wheels of the vehicle and place the vehicle on stands. Disconnect outlet hose (1). Connect the hose (2) to the outlet hose and drain the working fluid...

Steering gear — removal and installation
Installation elements of the steering gear with hydraulic booster Withdrawal Disconnect the ground wire from the battery. Drain the fluid from the booster hydraulic...

Steering gear — repair (early car models)
Disassembly Remove the tip from the tie rod. Remove the boot from the ball joint. Remove the boot clamps. Remove the boot from the traction. Disconnect the power tube...

Features of the repair of the steering mechanism of models of later years of production
Remove the protective covers from the rail housing. Check crank torque with a torque wrench (1), rotate the rack and pinion steering gear within one revolution within 4...

Power steering pump — removal and installation
Installation elements of the steering pump of models of later years of production 1 - bypass bolt; 2 - fitting; 3 - drive belt; 4 - pressure switch sensor connector; 5 -...