Car steering Hyundai Accent 3

Steering Specifications
Characteristic Rated value Free play on the steering wheel rim 30 mm Steering angle (inner wheel) without power steering: 38°58'±1°30' with power steering: 39°57'±1°30'...

Steering check
Checking wheel angles 1. With special equipment (A) measure the steering angles and compare them with the nominal values. 2. If the measured value differs from the...

Changing the hydraulic fluid
1. Raise the front of the vehicle. 2. Disconnect the return hose from the power steering reservoir, and plug the reservoir fitting. 3. Connect a tube to the disconnected...

Checking the pressure in the hydraulic system
1. Thermometer; 2. Pressure gauge; 3. Gauge tap (closed); 4. Discharge pipe; 5. Power steering tank; 6. Discharge pipe; 7. Pump; 8. Gauge adapter 1. Disconnect the...

Removal and installation of a steering column
1. Steering wheel; 2. Steering column; 3. Intermediate shaft; 4. Bolt; 5. Screw; 6. Nut; 7. Tilt adjustment lever; steering column; 8. Top casing; 9. Multifunctional;...

Disassembly and assembly of the steering column
Disassembly 1. Use a chisel to knock out the groove on the screw heads (1) bracket (2) ignition switch (3) and unscrew them with a screwdriver. Alternatively, these...

Removal and installation of the steering mechanism
1. Protective cuff; 2. Dust cover; 3. Retaining ring; 4. Oil seal; 5. Bearing; 6. Gear; 7. Oil seal; 8. Needle bearing; 9. Reiki stop; 10. Spring; 11. Locknut; 12. Plug;...

Disassembly and assembly of the steering mechanism
Disassembly 1. Clamp the steering gear (1) in a vice (2) with protective aluminum lining. Attention: when fixing, the vise jaws must be located on the mounting part of...

Check of a condition of details of the steering mechanism
Steering gear 1. Scrolling the gear at a frequency of 1 revolution in 4-6 seconds, measure the resistance to rotation of the steering gear. Rated value: 0.6-1.3 Nm. This...

Removal and installation of the power steering pump
1. Oil tank; 2. Booster pump; 3. Pressure tube; 4. Return tube; 5. Steering gear; 6. Fluid cooler Withdrawal 1. Loosen the hollow screw and disconnect the pressure...

Disassembly and assembly of the pump
1. Lid; 2. Gasket; 3. Cam washer; 4. Rotor and plates; 5. Side plate; 6. Spring; 8. O-ring; 9. O-ring; 10. Pump housing; 11. Spring; 12. Flow control valve; 13. Fitting;...

Dismantling and assembly of the main brake cylinder
1. Lid; 2. Mesh filter; 3. Brake fluid reservoir; 4. Rubber bushings; 5. Pin; 6. Retaining ring; 7. Primary piston; 8. Secondary piston; 9. Master cylinder; 10. Brake...