Withdrawal
1. Disconnect a wire from the negative plug of joint stock bank.
2. Remove the front bumper.
3. Remove the ambient air temperature sensor (A).
Installation
4. Installation is carried out in the reverse order of removal.
Examination
5. Turn off the ignition.
6. Disconnect the sensor connector.
7. Using an ohmmeter, check the change in the resistance of the sensor depending on the air temperature. If the measured value is out of specification, replace the sensor.
| Air temperature,°С | Resistance, kOhm±3% |
| -10 | 164 |
| 0 | 97,5 |
| 10 | 59,6 |
| 20 | 37,5 |